Truck Test 2
1.How many full turns should the handle of the trailer landing gear make after cranking up the trailer landing gear of a Class I vehicle?
Correct!
Wrong!
Progress
01/45
Truck Test 2
2.Which of the following should be engaged when safely checking the cab of a Class I tractor trailer vehicle?
Correct!
Wrong!
Progress
02/45
Truck Test 2
3.Which of the following vehicles require a medical certificate or examination as a requirement for driving?
Correct!
Wrong!
Progress
03/45
Truck Test 2
4.Which of the following is NOT part of the Outside Light and General Check of a Class II vehicle?
Correct!
Wrong!
Progress
04/45
Truck Test 2
5.Once the air lines and light cords are disconnected in logical order, where should they be secured afterwards?
Correct!
Wrong!
Progress
05/45
Truck Test 2
6.While inspecting a vehicle prior to use, what should an operator do when they come across lights on the truck and trailer that are dirty or grimy?
Correct!
Wrong!
Progress
06/45
Truck Test 2
7.For a goose neck hitch, what needs to be in place for the coupling to be secure?
Correct!
Wrong!
Progress
07/45
Truck Test 2
8.The coupling of the 5th wheel jaws and kingpin should be checked and double checked for which of the following?
Correct!
Wrong!
Progress
08/45
Truck Test 2
9.The windshield of the Class I tractor trailer vehicle should be checked for which of the following before operating?
Correct!
Wrong!
Progress
09/45
Truck Test 2
10.Tires should always be checked for which of the following before operating the vehicle?
Correct!
Wrong!
Progress
010/45
Truck Test 2
11.Often the tractor and trailer are connected by 5th wheel jaws and a kingpin, but there are other types of hitches used as well. What is another type of hitch used?
Correct!
Wrong!
Progress
011/45
Truck Test 2
12.In a Class I vehicle, from what position should the operator check to see if the jaws are open and the pin is lined up with the 5th wheel?
Correct!
Wrong!
Progress
012/45
Truck Test 2
13.How many passengers are Class IV permitted to transport at one time?
Correct!
Wrong!
Progress
013/45
Truck Test 2
14.Which is the last step an operator must preform during an uncoupling procedure of a Class I vehicle?
Correct!
Wrong!
Progress
014/45
Truck Test 2
15.What part of a Class II vehicle must be check for free play during the in cab pre-operating inspection?
Correct!
Wrong!
Progress
015/45
Truck Test 2
16.Which of the following vehicles cite a valid PEI driver's licence as a requirement for driving?
Correct!
Wrong!
Progress
016/45
Truck Test 2
17.Which gear should the handle of the trailer landing gear be in during the uncoupling of a Class I vehicle?
Correct!
Wrong!
Progress
017/45
Truck Test 2
18.Once the landing gear on a Class III vehicle has been raised, the handle must be reversed and then secured in which of the following ways?
Correct!
Wrong!
Progress
018/45
Truck Test 2
19.After applying the tractor parking brake during the uncoupling of a Class tractor trailer, it's necessary to pause to ensure which of the following?
Correct!
Wrong!
Progress
019/45
Truck Test 2
20.Which of the following is NOT required for the Class I Tractor Trailer driver's licence?
Please select 2 correct answers
Correct!
Wrong!
Progress
020/45
Truck Test 2
21.Which of the following is NOT part of the In Cab inspection of a Class II vehicle?
Correct!
Wrong!
Progress
021/45
Truck Test 2
22.When coupling a trailer with a ball hitch, where must the ball be in relation to the hitch for it to be secured properly?
Correct!
Wrong!
Progress
022/45
Truck Test 2
23.Before operating the truck and trailer of a Class I vehicle, what must the exhaust be checked for?
Correct!
Wrong!
Progress
023/45
Truck Test 2
24.Which of the following vehicles might be equipped with safety chains for use during the coupling and uncoupling procedure?
Correct!
Wrong!
Progress
024/45
Truck Test 2
25.Before a licence can be upgraded, what must be completed before the road test can be conducted?
Correct!
Wrong!
Progress
025/45
Truck Test 2
26.When placing chock blocks during the uncoupling procedure, where do they go in relation to the trailer?
Correct!
Wrong!
Progress
026/45
Truck Test 2
27.When attaching the trailer to the tractor, this process is called what?
Correct!
Wrong!
Progress
027/45
Truck Test 2
28.Which seatbelts must be in good working order for Class I, Class II, Class III, and Class IV vehicles?
Correct!
Wrong!
Progress
028/45
Truck Test 2
29.When coupling the truck and trailer for a Class III vehicle, the wheel chocks must be removed after the trailer has been successfully hitched to the truck. Which of the following must be checked before the rig can leave after they have been removed?
Correct!
Wrong!
Progress
029/45
Truck Test 2
30.When removing the trailer from the tractor, this process is called what?
Correct!
Wrong!
Progress
030/45
Truck Test 2
31.Which step in the uncoupling procedure for a Class III vehicle comes after the 5th wheel locks have been locked to an 'open position'?
Correct!
Wrong!
Progress
031/45
Truck Test 2
32.What general method of inspection is required around the vehicle before each and every time a driver takes the truck out for a days work?
Correct!
Wrong!
Progress
032/45
Truck Test 2
33.What is the first step in a Class III uncoupling procedure?
Correct!
Wrong!
Progress
033/45
Truck Test 2
34.What device should be engaged in a Class III vehicle while testing the coupling of the 5th wheel jaw and kingpin or goose neck hitch and ball?
Correct!
Wrong!
Progress
034/45
Truck Test 2
35.What brake should be applied after the operator has tested the coupling of the 5th wheel jaws and the kingpin?
Correct!
Wrong!
Progress
035/45
Truck Test 2
36.Which type of brakes need to be checked before operating the tractor trailer?
Correct!
Wrong!
Progress
036/45
Truck Test 2
37.What is the final step a driver must perform when disconnecting the tractor from the trailer during the uncoupling procedure in a Class I vehicle?
Correct!
Wrong!
Progress
037/45
Truck Test 2
38.Where should the operator of the tractor trailer stand when checking and adjusting the height of the trailer?
Correct!
Wrong!
Progress
038/45
Truck Test 2
39.In what order should the air lines and light cord be connected?
Correct!
Wrong!
Progress
039/45
Truck Test 2
40.When should the hand control valve be released during the coupling procedure in a Class I coupling procedure?
Correct!
Wrong!
Progress
040/45
Truck Test 2
41.Why is it necessary to check behind the trailer and remove any obstacles after the wheel chock blocks have been put in place?
Correct!
Wrong!
Progress
041/45
Truck Test 2
42.Which three security and exit components must be checked in the cab of the vehicle during the Class III pre-operating inspection?
Correct!
Wrong!
Progress
042/45
Truck Test 2
43.How long must a person have their driver's licence before they are allowed to upgrade to a Class II?
Correct!
Wrong!
Progress
043/45
Truck Test 2
44.What is the minimum age requirement for obtaining the Class I Driver's Licence?
Correct!
Wrong!
Progress
044/45
Truck Test 2
45.When should the wheel chocks be removed from the tractor trailer?
Correct!
Wrong!
Progress
045/45
Your Progress 0/45
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
0 Correct
x 0 Incorrect
- Passing Score 80%
X
Ace the DMV Exam on
Ace the DMV Exam on Your First Attempt
Unlimited mock tests
Access Over 1000 Exam Like Questions for Just $3
Ace the DMV Exam on
Your First Attempt